Projects-4
This is a set, Hard top frame and seat for a 89 model 28-32 foot center console out of Belhaven, NC right on the water this boat has been for 15 years. When we got these parts, it was easy to see the damaged areas from 10 feet away and the factory anodized finish was gone. We purged these parts at 450 degs 4 times flushing out almost all of the contaminates and coated them with our Chrome and Clear top coat. Now these are ready for the water again with a new life span.
This is a set of engine covers & Honda wheels in our Bright Red finish. These are for a bike shop in the Greenville area, Give (Mike) at UnderDog Motorsports a call to get your bike ready for the summer @ 252-258-9918 or e-mail him at wigginst3@yahoo.com . See more about Underdog Motorsports at the bottom of our motorcycle section.
Mustang engine components and a set of ceramic coated with a polished aluminum headers finish headers.
Before & After shot of this 1930's glider, from 80 years of back yard painting and touch ups to this with our Sherwin Williams Satin Black finish as shown on the right.
This is a Chevy intake, we degrease & blasted the surface after masking off all of the seating surfaces were masked off and coated it with High Gloss Clear.
This is a Fuel tank cover, runs the entire length of the gas tank. This is coated with our Wet Black finish and has a very high reflection.
This Was a chrome head light trim ring. It is now coated with our Wet Black finish with a very high reflection.
These (right) are rear fender
mounts, head light ring and
mounts also in our Wet Black.
We had previously coated the
sissy bar and chain guard on
this bike, now it is almost
completely blacked out.
This project started out like this, had a few problems and changed to this.
Candy Blue finish. finishing the engine covers and this project will be finished
This is an extended swing arm coated with our Satin Black
This is a 240 wide wheel swing arm coated with our Flat Black
These pieces are 125 year old cast iron front porch supports coated with our Satin Black finish.
These pieces are 125 year old cast iron front porch trims coated with our Satin Black finish.
Another sharp set of wheels. We coated the centers and back side with our Satin Black finish. The picture does not do these wheel justice.
These are Fountain Powder Boat swim platform mounting brackets after purging salt damage and re-coating with Sherwin Williams White Gloss TGIC Polyester powder. These after (2) two coats are good for many years to come.
These are 2004 Fountain Powder Boats swim platform mounts showing salt damage.
